KLOPFENSTEIN AA300R Assembly Instructions And Parts List

Need Help? Call us at 419-884-2900 with questions or comments.

ASSEMBLY INSTRUCTIONS & PARTS LIST FOR THE

Step 3: Attach the telescoping

upright to the pivot bracket with

the pivot bracket bolt, washer and

locknut. Screw in the pivot

bracket locking knobs and insert

the upright into the assembled

base unit. Screw in lever handle.

Tighten the pivot bracket bolt &

nut until there is enough resis-

tance that the top will not unex-

pectedly fall forward or back-

ward when the locking knobs

are loosened to adjust tabletop

tilt angle. Do not over tighten,

making it difficult to make tilt

adjustments.

OPTIONAL ROTATOR

Step 1: Fit Cen-

ter Upright onto

base as shown.

Your table top with optional

rotator is heavier than our

normal tops without the rota-

tor. To compensate for the

extra weight we have added

an extra half length of spring

inside the Center Upright.

The extra half spring and the

full spring are already inside

the upright. The full spring

is stacked on top of the half

spring with the factory fin-

ished end of the half spring

up and the cut off end

down. Your springs will work

better if you keep them

stacked this way.

Related Manuals for KLOPFENSTEIN AA300R

Art table with optional rotator (2 pages)

Summary of Contents for KLOPFENSTEIN AA300R

• Page 1 ASSEMBLY INSTRUCTIONS & PARTS LIST FOR THE OPTIONAL ROTATOR KLOPFENSTEIN ART TABLE WITH (AA300R) PARTS: Pivot Bracket Step 1: Fit Cen- Locking Knobs ter Upright onto base as shown. Pivot Bracket Bolt, Locknut & Washers Set Bolts to Lock Center Upright Onto Base.
• Page 2 OPTIONAL ROTATING ADJUSTING THE ART TABLE TOP FOR HORIZONTAL OR VERTICAL WORK Spring loaded steel plunger locks rotating top into a vertical or hori- zontal orientation. Pull out on plunger knob to rotate top. An easy way to ad- just the tabletop height, and rotate it to a vertical or hori- zontal orientation is.